M95010-BN3 datasheet(13/37 Pages) STMICROELECTRONICS

13 / 37 page

13/37

M95040, M95020, M95010

Write Enable (WREN)

The Write Enable Latch (WEL) bit must be set pri-

or to each WRITE and WRSR instruction. The only

way to do this is to send a Write Enable instruction

to the device.

As shown in Figure 8., to send this instruction to

the device, Chip Select (S) is driven Low, and the

bits of the instruction byte are shifted in, on Serial

Data Input (D). The device then enters a wait

state. It waits for a the device to be deselected, by

Chip Select (S) being driven High.

Figure 8. Write Enable (WREN) Sequence

Write Disable (WRDI)

One way of resetting the Write Enable Latch

(WEL) bit is to send a Write Disable instruction to

the device.

As shown in Figure 9., to send this instruction to

the device, Chip Select (S) is driven Low, and the

bits of the instruction byte are shifted in, on Serial

Data Input (D).

The device then enters a wait state. It waits for a

the device to be deselected, by Chip Select (S) be-

ing driven High.

The Write Enable Latch (WEL) bit, in fact, be-

comes reset by any of the following events:

–Power-up

–

WRDI instruction execution

–

WRSR instruction completion

–

WRITE instruction completion

–

Write Protect (W) line being held Low.

Figure 9. Write Disable (WRDI) Sequence

AI01441D

34567

High Impedance

Instruction

AI03790D

34567

High Impedance

Instruction

M95010-BN3 Fiches technique(PDF) 13 Page - STMicroelectronics

M95010-BN3 Fiches technique(HTML) 13 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Fiches technique Télécharger

Lien URL