DS1673E-3 datasheet(2/18 Pages) MAXIM

2 / 18 page

DS1673

2 of 18

DETAILED DESCRIPTION

The microprocessor monitor circuitry of the DS1673 provides three basic functions. First, a precision

temperature-compensated reference and comparator circuit monitors the status of VCC. When an out-of-

tolerance condition occurs, an internal power-fail signal is generated which forces the reset to the active

state. When VCC returns to an in-tolerance condition, the reset signals are kept in the active state for

250 ms to allow the power supply and processor to stabilize. The second microprocessor monitor function

is pushbutton reset control. The DS1673 debounces a pushbutton input and guarantees an active reset

pulse width of 250 ms. The third function is a watchdog timer. The DS1673 has an internal timer that

forces the reset signals to the active state if the strobe input is not driven low prior to watchdog timeout.

The DS1673 also provides a 3-channel, 8-bit successive approximation analog-to-digital converter. The

converter has an internal 2.55V (typical) reference voltage generated by an on-board band-gap circuit.

The ADC is monotonic (no missing codes) and has an internal analog filter to reduce high frequency

noise.

OPERATION

The block diagram in Figure 1 shows the main elements of the DS1673. The following paragraphs

describe the function of each pin.

DS1673 BLOCK DIAGRAM Figure 1

DS1673E-3 Fiches technique(PDF) 2 Page - Maxim Integrated Products