DS1306ESLASHTR datasheet(8/21 Pages) DALLAS

8 / 21 page

DS1306

8 of 21

STATUS REGISTER (READ 10H)

BIT7

BIT6

BIT5

BIT4

BIT3

BIT2

BIT1

BIT0

IRQF1

IRQF0

IRQF0 (Interrupt 0 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current

time has matched the Alarm 0 registers. If the AIE0 bit is also a logic 1, the INT0 pin goes low. IRQF0 is

cleared when the address pointer goes to any of the Alarm 0 registers during a read or write. IRQF0 is

activated when the device is powered by VCC1, VCC2, or VBAT.

IRQF1 (Interrupt 1 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current

time has matched the Alarm 1 registers. If the AIE1 bit is also a logic 1, the INT1 pin generates a 62.5ms

active-high pulse. IRQF1 is cleared when the address pointer goes to any of the alarm 1 registers during a

read or write. IRQF1 is activated only when the device is powered by VCC2 or VBAT.

TRICKLE CHARGE REGISTER (READ 11H, WRITE 91H)

This register controls the trickle charge characteristics of the DS1306. The simplified schematic of Figure

3 shows the basic components of the trickle charger. The trickle charge select (TCS) bits (bits 4–7)

control the selection of the trickle charger. In order to prevent accidental enabling, only a pattern of 1010

enables the trickle charger. All other patterns disable the trickle charger. The DS1306 powers up with the

trickle charger disabled. The diode select (DS) bits (bits 2–3) select whether one diode or two diodes are

connected between VCC1 and VCC2. The diode select (DS) bits (bits 2–3) select whether one diode or two

diodes are connected between VCC1 and VCC2. The resistor select (RS) bits select the resistor that is

connected between VCC1 and VCC2. The resistor and diodes are selected by the RS and DS bits as shown

in Table 2.

Figure 3. PROGRAMMABLE TRICKLE CHARGER

DS1306E/TR Fiches technique(PDF) 8 Page - Dallas Semiconductor