L99MC6 datasheet(29/55 Pages) STMICROELECTRONICS

29 / 55 page

L99MC6

Functional description of the SPI

Doc ID 16523 Rev 2

29/32

8.2

SPI communication flow

8.2.1

General description

The proposed SPI communication is based on a standard SPI interface structure using CSN

(chip select not), SDI (serial data in), SDO (serial data out/error) and SCK (serial clock)

signal lines.

At the beginning of each communication the master reads the <SPI-frame-ID> register

(ROM address 3EH) of the slave device. This 8-bit register indicates the SPI frame length

(16 bit for the L99MC6) and the availability of additional features.

Each communication frame consists of an instruction byte which is followed by 1 data byte

(see Figure 12).

The data returned on SDO within the same frame always starts with the <Global Status>

is ‘In-frame-response’, see Figure 12).

For Write cycles the <Global Status> register is followed by the previous content of the

addressed register.

For Read cycles the <Global Status> register is followed by the content of the addressed

8.2.2

Command byte

Each communication frame starts with a command byte. It consists of an operating code

which specifies the type of operation (<Read>, <Write>, <Read and Clear Status>, <Read

Device Information>) and a 6-bit address.

Table 12.

Command byte - general description

MSB

LSB

Operating code

Address

OC1

OC0

Table 13.

Data byte - general description

MSB

LSB

Bit7

Bit6

Bit5

Bi4

Bit3

Bit2

Bit1

Bit0

Table 14.

Command byte

MSB

LSB

Operating code

Address

OC1

OC0

L99MC6 Fiches technique(PDF) 29 Page - STMicroelectronics

L99MC6 Fiches technique(HTML) 29 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Fiches technique Télécharger

Lien URL