AMC1300BDWVR datasheet(21/38 Pages) TI2

21 / 38 page

8.3.2 Isolation Channel Signal Transmission

The AMC1300 uses an on-off keying (OOK) modulation scheme, as shown in Figure 8-1, to transmit the

modulator output bitstream across the SiO2-based isolation barrier. The transmit driver (TX) shown in the

Functional Block Diagram transmits an internally generated, high-frequency carrier across the isolation barrier

to represent a digital one and does not send a signal to represent a digital zero. The nominal frequency of the

carrier used inside the AMC1300 is 480 MHz.

The receiver (RX) on the other side of the isolation barrier recovers and demodulates the signal and provides

the input to the fourth-order analog filter. The AMC1300 transmission channel is optimized to achieve the

highest level of common-mode transient immunity (CMTI) and lowest level of radiated emissions caused by the

high-frequency carrier and RX/TX buffer switching.

Modulator Bitstream

on High-side

Internal Clock

Signal Across Isolation Barrier

Recovered Sigal

on Low-side

Figure 8-1. OOK-Based Modulation Scheme

www.ti.com

AMC1300

SBAS895D – MAY 2018 – REVISED MAY 2022

Submit Document Feedback

Product Folder Links: AMC1300

AMC1300BDWVR Fiches technique(PDF) 21 Page - Texas Instruments