ST10F271Z1 datasheet(86/185 Pages) STMICROELECTRONICS

86 / 185 page

System reset

ST10F271Z1

86/185

Figure 22.

Synchronous short / long hardware reset (EA = 0)

P0[15:13]

not transparent

RSTF

P0[12:2]

transparent

not t.

P0[1:0]

not t.

not transparent

RST

1024 TCL

3..8 TCL3)

2) VRPD > 2.5V Asynchronous Reset not entered

200mA Discharge

RPD

RSTOUT

At this time RSTF is sampled HIGH or LOW

so it is SHORT or LONG reset

(After Filter)

RSTIN

< 1032 TCL

≤4 TCL5)

≤12 TCL

≤ 500 ns

≥ 50 ns

≤ 500 ns

≥ 50 ns

≤ 500 ns

≥ 50 ns

ALE

8 TCL

1. RSTIN assertion can be released there. Refer also to Section 21.1 for details on minimum pulse duration.

2. If during the reset condition (RSTIN low), RPD voltage drops below the threshold voltage (about 2.5V for 5V operation)

the asynchronous reset is then immediately entered.

4. RSTIN pin is pulled low if bit BDRSTEN (bit 3 of SYSCON register) was previously set by software.

Bit BDRSTEN is cleared after reset.

5. Minimum RSTIN low pulse duration shall also be longer than 500ns to guarantee the pulse is not masked by the

internal filter (refer to Section 21.1).

Notes:

3. 3 to 8 TCL depending on clock source selection.

8 TCL

not t.

ST10F271Z1 Fiches technique(PDF) 86 Page - STMicroelectronics

ST10F271Z1 Fiches technique(HTML) 86 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL