ADC12DL080

SNAS345A – FEBRUARY 2006 – REVISED APRIL 2013

www.ti.com

DYNAMIC PERFORMANCE

To achieve the best dynamic performance, the clock source driving the CLK input must be free of jitter. Isolate

the ADC clock from any digital circuitry with buffers, as with the clock tree shown in Figure 46. The gates used in

the clock tree must be capable of operating at frequencies much higher than those used if added jitter is to be

prevented.

Best performance will be obtained with a differential input drive, compared with a single-ended drive, as

discussed in Single-Ended Operation and Driving the Analog Inputs.

As mentioned in LAYOUT AND GROUNDING, it is good practice to keep the ADC clock line as short as possible

and to keep it well away from any other signals. Other signals can introduce jitter into the clock signal, which can

lead to reduced SNR performance, and the clock can introduce noise into other lines. Even lines with 90°

crossings have capacitive coupling, so try to avoid even these 90° crossings of the clock line.

Figure 46. Isolating the ADC Clock from other Circuitry with a Clock Tree

7.0 COMMON APPLICATION PITFALLS

Driving the inputs (analog or digital) beyond the power supply rails. For proper operation, all inputs should

not go more than 100 mV beyond the supply rails (more than 100 mV below the ground pins or 100 mV above

the supply pins). Exceeding these limits on even a transient basis may cause faulty or erratic operation. It is not

uncommon for high speed digital components (e.g., 74F and 74AC devices) to exhibit overshoot or undershoot

that goes above the power supply or below ground. A resistor of about 47

Ω to 100Ω in series with any offending

digital input, close to the signal source, will eliminate the problem.

Do not allow input voltages to exceed the supply voltage, even on a transient basis. Not even during power up or

power down.

Be careful not to overdrive the inputs of the ADC12DL080 with a device that is powered from supplies outside

the range of the ADC12DL080 supply. Such practice may lead to conversion inaccuracies and even to device

damage.

Attempting to drive a high capacitance digital data bus. The more capacitance the output drivers must

charge for each conversion, the more instantaneous digital current flows through VDR and DR GND. These large

charging current spikes can couple into the analog circuitry, degrading dynamic performance. Adequate

bypassing and maintaining separate analog and digital areas on the pc board will reduce this problem.

Additionally, bus capacitance beyond the specified 10 pF/pin will cause tOD to increase, making it difficult to

properly latch the ADC output data. The result could, again, be an apparent reduction in dynamic performance.

The digital data outputs should be buffered (with 74ACQ541, for example). Dynamic performance can also be

improved by adding series resistors at each digital output, close to the ADC12DL080, which reduces the energy

coupled back into the converter output pins by limiting the output current. A reasonable value for these resistors

is 100

Ω.

28

Submit Documentation Feedback

Copyright © 2006–2013, Texas Instruments Incorporated

Product Folder Links: ADC12DL080