STM32F412RGY7PTR datasheet(79/201 Pages) STMICROELECTRONICS

No de pièce	STM32F412RGY7PTR

Description	Arm®-Cortex®-M4 32b MCUFPU, 125 DMIPS, 1MB Flash, 256KB RAM, USB OTG FS, 17 TIMs, 1 ADC, 17 comm. interfaces

PDF	201 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

79 / 201 page

DocID028087 Rev 7

79/201

STM32F412xE/G

Electrical characteristics

166

6.1.6

Power supply scheme

Figure 21. Power supply scheme

1. To connect PDR_ON pin, refer to Section: Power supply supervisor.

2. The 4.7 µF ceramic capacitor must be connected to one of the VDD pin.

3. VCAP_2 pad is only available on 100-pin and 144-pin packages.

4. VDDA=VDD and VSSA=VSS.

5. VDDUSB is a dedicated independent USB power supply for the on-chip full-speed OTG PHY module and

associated DP/DM GPIOs. VDDUSB value does not depend on the VDD and VDDA values, but it must be the

last supply to be provided and the first to disappear.

Caution:

Each power supply pair (for example VDD/VSS, VDDA/VSSA) must be decoupled with filtering

ceramic capacitors as shown above. These capacitors must be placed as close as possible

to, or below, the appropriate pins on the underside of the PCB to ensure good operation of

the device. It is not recommended to remove filtering capacitors to reduce PCB size or cost.

This might cause incorrect operation of the device.

STM32F412RGY7PTR Fiches technique(PDF) 79 Page - STMicroelectronics