SPEC NO: DSAD1552

REV NO: V.7

DATE: NOV/212005

PAGE: 6 OF 9

APPROVED: J. Lu

CHECKED: Tracy Deng

DRAWN: Y.W.WANG

ERP:1205000027

PHOTOCOUPLER

P/N: KB847

Fig. 11 Collector-emitter Saturation

Voltage vs. Forward Current

****NOTES ON HANDLING

1.Recommended soldering conditions (Dip soldering)

(1) Dip soldering

Temperature

260

°C or below (molten solder temperature)

Time

Less than 10 seconds.

Cycle

One cycle allowed to be dipped in solder including plastic mold portion.

Flux

Rosin flux containing small amount of chorine

(The flux with a maximum chlorine content of 0.2 Wt % is recommended.)

(2) Cautions

Fluxes

Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.

2.Cautions regarding noise

Be aware that power is suddenly into the componment any surge current may cause damage happen,

even if the voltage is within the absolute maximum ratings.