WIRING DIAGRAM

FAULT SIGNAL

The Dual Sensing Battery Isolator can use a solar panel or an external battery charger to

recharge. Use 300 amp fuse or smaller. Make sure the battery cables are sized for 300

amps. NOTE: The AIMS Power isolator may also be used as a standard ignition switch

isolator. Simply remove the battery monitor (black box) from the isolator and connect the

isolator's input to the ignition.

it is normal for the LED to illuminate for a brief time after the vehicle is turned OFF. If there is a

fault, the LED on the manual switch is set to indicate fault with a sequence of flickers to notify

the user. The LED will flicker in the following sequences:

Error 1

2 flickers

Over-Voltage > 15.5 V

Error 2

3 flickers

Voltage drop < 12.7 V

AIMS POWER | 9550 GATEWAY DR. | RENO, NV 89521 | WWW.AIMSCORP.NET