12

Use the wrench tool to tighten the nut to the panel, see picture 5.2.2. The nut must be screwed to a proper torque

range of 1.1 to 1.4 N·m.

Insert terminal into back of male and female connector. A “click” should be heard or felt when the terminal is seated

in right position. Terminals cannot be removed once seated.

If the terminals are not inserted in the correct position, the connector itself will not be fully assembled, the contacts

will not mate as intended, which will cause the connector to overheat and possibly cause a fire or safety risk.

Picture 5.2.2

Picture 5.2.3

Picture 5.2.4

Inspection

Use the contact depth inspection tool to the check if the contact is in the right position. The edge of connector hous-

ing should be located within the white area of the contact depth inspection tool.

Female Connector

Male Connector