SA9024 datasheet(11/23 Pages) PHILIPS

11 / 23 page

Philips Semiconductors

Objective specification

SA9024

900 MHz transmit modulator and 1.3 GHz

fractional–N synthesizer

1997 Aug 01

power control,

÷M (offset loop), SE (Tx offset loop synthesizer

enable), DUAL mode, Sleep Mode 1 and Sleep Mode 2.

The data for FDAC is stored by the B word into a temporary register.

When the A word is loaded, the data in this temporary register is

loaded together with the A word into the work registers to avoid false

temporary main synthesizer output caused by changes in fractional

compensation.

The A word contains new data for the main divider. The A word is

loaded into the working registers only when a main divider

synchronization signal is active to avoid phase jumps when

reprogramming the main divider. The synchronization pulse is

generated by the main divider when it has reached its terminal

count, at which time a main divider output pulse is also sent to the

main phase detector. This disables the loading of the A word each

main divider cycle during maximum of (NREF /

ƒREF) seconds.

Therefore, to be sure that the A word will be correctly loaded, the

STROBE signal must be high for at least (NREF /

ƒREF) seconds.

When programming the A word, the main charge pumps on output

PHP and PHI are set into the speed–up mode as soon as the A

word is latched into the working registers and remain so as long as

STROBE is held high.

SR01447

DATA

CLOCK

STROBE

CLOCK ENABLED–SHIFT IN DATA

CLOCK

DISABLED

STORE DATA

tSU

LAST

CLOCK

FIRST

CLOCK

tSU

D21

D23

VALID DATA CHANGE

Figure 5.

Serial Input Timing Sequence

SA9024 Fiches technique(PDF) 11 Page - NXP Semiconductors

SA9024 Fiches technique(HTML) 11 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Fiches technique Télécharger

Lien URL