TMD26721 datasheet(21/44 Pages) OSRAM

21 / 44 page

Page 20

ams Datasheet

Document Feedback

[v1-00] 2015-Mar-23

TMD2672 − Principles of Operation

I²C Protocol

Interface and control are accomplished through an I²C serial

compatible interface (standard or fast mode) to a set of registers

that provide access to device control functions and output data.

The devices support the 7-bit I²C addressing protocol.

The I²C standard provides for three types of bus transaction:

read, write, and a combined protocol (Figure 25). During a write

operation, the first byte written is a command byte followed by

data. In a combined protocol, the first byte written is the

command byte followed by reading a series of bytes. If a read

command is issued, the register address from the previous

command will be used for data access. Likewise, if the MSB of

the command is not set, the device will write a series of bytes

at the address stored in the last valid command with a register

address. The command byte contains either control information

or a 5-bit register address. The control commands can also be

used to clear interrupts.

The I²C bus protocol was developed by Philips (now NXP). For

a complete description of the I²C protocol, please review the

NXP I²C design specification at

http://www.i2c-bus.org/references.

Figure 25:

I²C Protocols

Data Byte

Slave Address

Command Code

...

I2C Write Protocol

I2C Read Protocol

I2C Read Protocol — Combined Format

Data

Slave Address

Data

...

Slave Address

Command Code

Data

...

Acknowledge (0)

Not Acknowledged (1)

Stop Condition

Read (1)

Start Condition

Repeated Start Condition

Write (0)

...

Continuation of protocol

Master-to-Slave

Slave-to-Master

TMD26721 Fiches technique(PDF) 21 Page - OSRAM GmbH

TMD26721 Fiches technique(HTML) 21 Page - OSRAM GmbH

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Fiches technique Télécharger

Lien URL