Philips Semiconductors

Product specification

PCK2510SL

50–150 MHz 1:10 SDRAM clock driver

2000 Dec 01

3

PIN DESCRIPTIONS

PIN NUMBER

SYMBOL

TYPE

NAME, FUNCTION, and DIRECTION

1

AGND

GND

Analog ground. AGND provides the ground reference for the analog circuitry.

2, 10, 14, 22

PWR

Power supply

3, 4, 5, 8, 9,

15, 16, 17, 20, 21

1Y (0–9)

OUT

Clock outputs. These outputs provide low-skew copies of CLK. Output bank 1Y (0–9) is enabled

via the G input. These outputs can be disabled to a logic-low state by de-asserting the G control

input. Each output has an integrated 25

Ω series-damping resistor.

6, 7, 18, 19

GND

GND

Ground

11

G

IN

Output bank enable. G is the output enable for outputs 1Y (0–9). When G is LOW, outputs 1Y

(0–9) are disabled to a logic LOW state. When G is HIGH, all outputs 1Y (0–9) are enabled and

switch at the same frequency as CLK.

12

FBOUT

OUT

Feedback output. FBOUT is dedicated for external feedback. It switches at the same frequency

as CLK. When externally wired to FBIN, FBOUT completes the feedback loop of the PLL.

FBOUT has an integrated 25

Ω series-damping resistor.

13

FBIN

IN

Feedback input. FBIN provides the feedback signal to the internal PLL. FBIN must be

hard-wired to FBOUT to complete the PLL. The integrated PLL synchronizes CLK and FBIN so

that there is nominally zero phase error between CLK and FBIN.

23

PWR

is bypassed and CLK is buffered directly to the device outputs.

24

CLK

IN

Clock input. CLK provides the clock signal to be distributed by the PCK2510SL clock driver.

CLK is used to provide the reference signal to the integrated PLL that generates the clock

output signals. CLK must have a fixed frequency and fixed phase for the PLL to obtain phase

lock. Once the circuit is powered up and a valid CLK signal is applied, a stabilization time is

required for the PLL to phase lock the feedback signal to its reference signal.

FUNCTION TABLE

INPUTS

OUTPUTS

G

CLK

1Y (0–9)

FBOUT

X

L

L

L

L

H

L

H

H

H

H

H