LM2902W datasheet(2/10 Pages) STMICROELECTRONICS

2 / 10 page

LM2902W

2/10

SCHEMATIC DIAGRAM (1/4 LM2902)

ABSOLUTE MAXIMUM RATINGS

Symbol

Parameter

Value

Unit

VCC

Supply Voltage

±16 to 32

Vid

Differential Input Voltage

-0.3 to Vcc + 0.3

Input Voltage

-0.3 to Vcc + 0.3

Output Short-circuit to Ground 1)

Short-circuit from the output to VCCcan cause excessive heating if VCC > 15V. The maximum output current is approximately 40mA independent of

the magnitude of VCC. Destructive dissipation can result from simultaneous short-circuit on all amplifiers.

Infinite

ptot

Power Dissipation

N Suffix

D Suffix

500

400

Iin

Input Current 2)

This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base junction of the input PNP

transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this diode action, there is also NPN parasitic action on

the IC chip. This transistor action can cause the output voltages of the Op-Amps to go to the VCC voltage level (or to ground for a large overdrive)

for the time duration than an input is driven negative. This is not destructive and normal output will set up again for input voltage higher than -0.3V.

Toper

Operating Free-Air Temperature Range

-40 to +125

°C

Tstg

Storage Temperature Range

-65 to +150

°C

LM2902W Fiches technique(PDF) 2 Page - STMicroelectronics

LM2902W Fiches technique(HTML) 2 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10

Fiches technique Télécharger

Lien URL