STM32H757AI datasheet(48/251 Pages) STMICROELECTRONICS

48 / 251 page

Functional overview

STM32H757xI

48/251

DS12931 Rev 1

All USART have a clock domain independent from the CPU clock, allowing the USARTx to

wake up the MCU from Stop mode.The wakeup from Stop mode is programmable and can

be done on:

•

Start bit detection

•

Any received data frame

•

A specific programmed data frame

•

Specific TXFIFO/RXFIFO status when FIFO mode is enabled.

All USART interfaces can be served by the DMA controller.

3.34

Low-power universal asynchronous receiver transmitter

(LPUART)

The device embeds one Low-Power UART (LPUART1). The LPUART supports

asynchronous serial communication with minimum power consumption. It supports half

duplex single wire communication and modem operations (CTS/RTS). It allows

multiprocessor communication.

The LPUARTs embed a Transmit FIFO (TXFIFO) and a Receive FIFO (RXFIFO). FIFO

mode is enabled by software and is disabled by default.

Table 6. USART features

USART modes/features(1)

1. X = supported.

USART1/2/3/6

UART4/5/7/8

Hardware flow control for modem

Continuous communication using DMA

Multiprocessor communication

Synchronous mode (Master/Slave)

Smartcard mode

Single-wire Half-duplex communication

IrDA SIR ENDEC block

LIN mode

Dual clock domain and wakeup from low power mode

Receiver timeout interrupt

Modbus communication

Auto baud rate detection

Driver Enable

USART data length

7, 8 and 9 bits

Tx/Rx FIFO

Tx/Rx FIFO size

STM32H757AI Fiches technique(PDF) 48 Page - STMicroelectronics

STM32H757AI Fiches technique(HTML) 48 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL