User Manual

15 of 33

Revision 1.6

2018-11-27

EVAL-M1-101T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M1-101T

4.2.2

MCEDesigner setup overview

After installing MCEDesigner installer, there is a shortcut for MCEDesigner on Windows desktop. Double click

the shortcut to open MCEDesigner and then open “IMC101T_xx.irc” file as shown in Figure 8.

Figure 8

MCEDesigner’s Main Display for EVAL-M1-101T

MCEDesigner programmer function can be used to program IMC101T-T038 firmware and/or System

parameters. To call this function, click on “Tools” menu and then select “Programmer” in the pull down list.

The pop-up window “Program IMC controller” will show up as in Figure 9.

To program both firmware and Drive System Parameters into IMC101T-T038 (which can happen when

programming for the first time the brand new devices with default factory setting, or when the new version of

iMOTION™ firmware is being downloaded), first click on the “Program Firmware and Parameter” radio button in

the “Program IMC controller” pop-up window. After that, select the Drive System Parameter file created using

MCEWizard by clicking on the “Browse…” button at the end of the “Program Parameter File” row, and then also

select the the IMC101T-T038_A_Vxxx.ldf file (which was included in the “IMC101T-T038 MCE Software Package”)

by clicking on the “Browse…” button at the end of “Program Firmware File” row. Finally, click on the “Start”

button to program the parameter file into the IMC101T-T038 IC.