CAUTION:

Risk Group 1: UV Emitted from this product.

Minimize exposure to eyes or skin. Use appropriate shielding and eye protection. Risk Group 1 (RG 1) products

are safe for most use applications, except for very prolonged exposures where direct ocular exposures may be

expected.

- IEC 62471

The following caution applies to UV, 395 nm models:

CAUTION:

Risk Group 2: UV Emitted from this product.

Eye or skin irritation may result from exposure. Use appropriate shielding and eye protection. Risk Group 2 (RG

2) products generally do not pose a realistic optical hazard if aversion responses limit the exposure duration or

where lengthy exposures are unrealistic.

- IEC 62471

Wiring

Wire Purpose

Cable Wire Color3

Continuous On

Mode

Strobed Mode

Terminal Block

Power Wires

Brown (1)

+24 V dc

+24 V dc

Pin 014

Blue (3)

common

common

Pin 02

Strobe Polarity

Control

Gray (5)

open

Active Low: open

Open — Active Low

Active High: connect to common (Blue wire)

Pin 02 — Active High

Strobe Voltage

Wires

White (2)

open

0 V dc = ON (Active Low)

+5 V dc to 24 V dc = OFF (Active Low)

Pin 04

0 V dc = OFF (Active High)

+5 V dc to 24 V dc = ON (Active High)

Black (4)

open

Strobe common

Pin 02

(1) +24V dc

(3) Common

(5)Active High/Active Low

(4) Strobe Common

(2) Strobe (+)

Figure 1. Pinouts for Mating Cordsets

Light Adjustment (Adjustable Intensity Models Only)

Figure 2. Potentiometer Adjuster

1. Remove the plug as shown in the figure, using a small

flat-blade screwdriver.

2. Adjust the light’s intensity by turning the 270° Intensity

potentiometer with the screwdriver. Apply power to the

light and turn the potentiometer all the way clockwise

for maximum intensity.

3. If the object to be sensed is too bright at maximum

intensity, turn the potentiometer down a little at a time,

testing with the object, until the correct brightness is

achieved.

4. When adjustment is complete, reinsert the plug.

3 For Banner-supplied wire.

LED Series Sealed High-Intensity Area Lights

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 153957 Rev. F