Method

Action

Result

Push Button

a. Present the Output OFF condition.

b. Five-click the Static button.

Threshold condition accepted

•

Display flashes “Sn6l,” then

"dr" twice

•

Sensor returns to RUN mode

with new settings

•

Arrow icon turns green

Threshold condition not accepted

•

Display flashes “FAIL” and

returns to “1St”

•

Arrow icon remains red

•

After 60 seconds, the sensor

returns to RUN mode (the Arrow

icon turns green) without

changing settings

Remote Input

a. Present the Output OFF condition.

b. Five-pulse the remote line.

T

T

T

T

T

T

T

T

T

Manual Adjust

Manual Adjust is used during Run mode and is accomplished using the push buttons only. Its behavior depends on whether

a switching threshold or a sensing window is used.

Switching Threshold:

•

Fine-tunes sensing sensitivity

•

Press “+” to increase; press “-” to decrease

Sensing Window:

•

Adjusts sensing window size (tolerance) for the single-point target condition

•

Press “+” to increase; press “-” to decrease

Method

Action

Result

Push Button16

Click "+" to increase, or click "-" to decrease.

or

Display briefly flashes the threshold setpoint

value as it is being changed

OR

Display flashes"inc" or "dEc" as the window

size is adjusted

or

Remote Input17

Not available with remote programming.

n/a

Sensor Setup

•

Configures sensor display and operating parameters

•

Changes are updated instantly

•

Click Dynamic (+) or double-pulse remote line to select an option

•

Click Static (-) or single-pulse remote line to advance

16 0.04 seconds ≤ "Click" ≤ 0.8 seconds

17 0.04 seconds ≤ T ≤ 0.8 seconds

10

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 64154 Rev. G