ADLCXP-1660 datasheet(2/3 Pages) ADL

2 / 3 page

ADLVIS-1660 2-CH CoaXPress

Rugged SFF Vision Board Solution

ADL Corporate: 4411 Morena Blvd. Suite 101 | San Diego, CA 92117-4345

T: 858.490.0597

F: 858.490.0599

sales@adl-usa.com

www.adl-usa.com

ADL Germany: Eiserfelder Straße 316 | D-57080 Siegen, Germany

T: +49 (0) 271.250.810.0

F: +49 (0) 271.250.810.20

sales@adl-europe.com

www.adl-europe.com

TECHNICAL SPECIFICATIONS - ADLVIS-1660

FEATURE

FUNCTION

REMARKS

Interface Features

Connectors

• 2x CXP-6 DIN 1.0/2.3 female connectors

• System I/O: 26p D-sub connector

• Camera Power Input: 4p 0.1 in Molex KK 7478 male

• C2C Link: 2x3 6p 0.1 in header

Lamp Indicators

• ‘A’ ‘B’ HOST LEDS: 2x bi-color red/green

• FPGA Status LED: bi-color red/green

• Board Status LED: bi-color red/green

Interface Standards

• CoaXPress 1.0 and 1.1

Aggregated Camera Data Transfer Rate

• 12.5 Gbits/s (1250MB/s) Maximum

• Power Over CoaXPress

PoCXP Safe Power

• 17W of 24VDC regulated power per CoaXPress port

• PoCXP device detection and automatic power-on

• Overload and short-circuit protections

24V Power Input

• Connects to Auxiliar Power input on CoaXpress module

• Camera Support

Types

• Area-Scan Cameras:

• Gray-scale and color (RGB and Bayer CFA)

• Single-tap (1x-1Y) progressive scan

Pixel Formats Supported

• Raw, Monochrome, Bayer, RGB, and RGBA (PFNC names):

• Raw

• Mono8, Mono10, Mono12, Mono14, Mono16

• BayerXX8, BayerXX10, BayerXX12, BayerXX14, BayerXX16 where XX=GR, RG, GB, or BG

• RGB8, RGB10, RGB12, RGB14, RGBA16

Area Scan Camera Control

• External hardware trigger with optional delay and trigger decimation

• Accurate control of strobe position with support for early/late strobe pulses

GPIO (General Purpose Input/Output

10 I/O Lines

• 2x differential inputs (DIN)

• 2x single-ended TTL I/O (TTLIO)

• 4x Isolated Inputs (IIN)

• 2x Isolated Outputs (IOUT)

Usage

• Any I/O input line can be used by any LIN tool of the I/O Toolbox

• I/O input lines can be used by any QDC tool in I/O toolbox to decode A/B signals of a motion encoder

• LIN and QDC tool outputs can be further processed by other tools (DIV, MDV, DEL) to generate trigger events such as:

cycle trigger, cycle sequence trigger, start-of-scan trigger and end-of-scan trigger.

*Data subject to change without notice.

ADLCXP-1660 Fiches technique(PDF) 2 Page - ADL Embedded Solutions

ADLCXP-1660 Fiches technique(HTML) 2 Page - ADL Embedded Solutions

Html Pages

1 2 3

Fiches technique Télécharger

Lien URL