DM320016 datasheet(2/6 Pages) MICROCHIP

2 / 6 page

DS40001739A-page 2

Advance Information

 2014 Microchip Technology Inc.

DM320016

Single-Touch Gestures

Perform one of these single-touch gestures decoded in

firmware and see the icon in the display below.

FIGURE 3:

SINGLE-TOUCH GESTURES

DEVELOPMENT MODE OPERATION

This mode is intended to allow the device to connect to

a PC through the PKSA for evaluation with Microchip’s

PCU. The PCU must be installed on your local machine

to utilize this mode. Please download this utility from

the DM320016 device page.

• Toggle SW1 to OFF (PKSA will supply power)

• Toggle SW2 to DEV

• Connect PKSA to PKS header using the included

6-pin header

• Connect USB mini cable between PKSA and host

• Launch PCU utility and confirm the board is

connected

The PCU will connect automatically and display the

green CONNECTED status, and all tabs and parame-

ter adjustments are accessible.

Please reference the PCU manual (www.micro-

chip.com/pagehandler/en-us/technology/mtouch-

screens/resources/software.html) and the MTCH6301

device page (http://www.microchip.com/wwwproducts/

Devices.aspx?product=MTCH6301) for more details to

evaluate this design.

FIGURE 4:

KIT CONFIGURATION

PROGRAMMING

There is a header included on the board for

programming the MTCH6301. This header is marked

PGM.

Supported Microchip programming devices include:

• PICkit™ 3

• ICD 3

RESTORING FACTORY DEFAULTS

While using the PCU software, it is possible to adjust

particular settings outside of expected operating

ranges. It may be necessary to force the board to

factory default settings to restore functionality.

To restore the DM320016 to factory defaults:

• Detach the DM320016 from all devices before

turning SW1 to the OFF position and the SW2

switch to the DEV position

• Connect the PKSA to the PKS header

• Open the PCAP Configuration Utility and click the

SHOW ADVANCED PARAMETERS check box in

the lower left-hand corner, which will display a list

of additional options

• Click the RESTORE FACTORY DEFAULTS

button

• Wait for the CONTROLLER FACTORY

DEFAULTS RESTORED text to appear

• Close the utility and disconnect the DM320016

Once the DM320016 stops receiving power from the

PKSA, the factory defaults will be restored. To verify

that the device has been restored, move SW2 so that

DEMO is selected and change SW1 to the ON position.

Normal operation should be restored.

Single Tap

Double Tap

Tap and Hold

Swipe Up

Swipe Up and Hold

Swipe Down

Swipe Down and Hold

Swipe Left

Swipe Left and Hold

Swipe Right

Swipe Right and Hold

DM320016 Fiches technique(PDF) 2 Page - Microchip Technology

DM320016 Fiches technique(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6

Fiches technique Télécharger

Lien URL