Features
• STEVAL-IOM001V1
– IO-Link master PHY based on L6360
– Interrupt diagnostics pin
– I²C and UART interface
– SPI (slave) interface
– 65 mA selectable (3.3 or 5.0 V) linear regulator
– CQ (push-pull) and L+ (high side) switches
– IQ additional IEC61131-2 type 1 digital input
– L+ and CQ overload and overheating protections with non-dissipative cutoff
function
– QFN-26L (3.5x5x1 mm) package
– Operating voltage range from 18 to 32.5 V
– Additional high side switch for L+ heavy loads (IPS161H)
– LEDs for status and diagnostics
– Ground and VCC wire break protections
– EMC compliance with IEC61000-4-2, IEC61000-4-3, IEC61000-4-5
– Equipped with ST morpho connectors
– CE certified
– RoHS and China RoHS compliant
• NUCLEO-F446RE
– STM32F446RET6 32-bit Micro-controller based on ARM® Cortex®-M4 core
(180 MHz max.) with 512-Kbyte Flash memory and 128 (+4) Kbyte RAM
– Two types of extension resources: Arduino™ UNO Revision 3 connectivity
and ST morpho extension pin headers for full access to all STM32 I/Os
– Mbed-enabled (http://mbed.org)
– On-board ST-LINK/V2-1 debugger/programmer with SWD connector:
selection-mode switch to use the kit as a standalone ST-LINK/V2-1
– Two push-buttons: USER and RESET
Description
The P-NUCLEO-IOM01M1 is an STM32 Nucleo pack composed of the STEVALIOM001V1
and the NUCLEO-F446RE boards. The STEVAL-IOM001V1 is a single
IO-Link master PHY layer (L6360) while the NUCLEO- F446RE runs an IO-Link stack
rev 1.1 (developed by and property of TEConcept GmbH, license limited to 10k
minutes, renewable without additional costs).
The STM32 Nucleo pack provides an affordable and easy-to-use solution for the
evaluation of IO-Link applications, L6360 communication features and robustness,
together with the STM32F446RET6 computation performance. The pack, hosting up
to four STEVAL-IOM001V1 to build a quad port IO-Link master, can access the IOLink
physical layer and communicate with IO-Link Devices.
You can evaluate the tool via the dedicated GUI (IO-Link Control Tool©, property of
TEConcept GmbH) or use it as an IO-Link master bridge accessible from the
dedicated SPI interface: source code of demo project (Low-Level IO-Link Master
Access Demo Application, developed by TEConcept GmbH) and API specification are
available for free.