Note: There are two solder jumpers on the back of the 90R labeled CO and DO (clock out and data
out) that can be cut to interrupt those signals in case you make a closed-loop design where you
don’t want the clock and data from your last LED to interfere with the clock and data to your first. It is
critical that you cut the traces in the jumpers of the last board in the loop before you power up your
LEDs if you’ve put together a continuous loop of Lumenati boards. Otherwise, it is likely that you’ll
burn out a couple of LEDs.
 Dimensions: 35.7mm x 17.7mm x 3.2mm (1.4" x 0.7" x 0.12")
 Weight: 1.4g