General Description
The MIC826 is a low-current, ultra-small, voltage
supervisor with manual reset input, watchdog timer,
and active-high and active-low push-pull outputs. The
reset outputs are asserted and held when the supply
voltage falls below the factory-programmed threshold
voltage, when the /MR pin is pulled low, or if the
watchdog times out. Reset is asserted for the reset
timeout delay after the supply voltage increases above
the rising threshold voltage or when manual reset input
is asserted high.
The MIC826 features an integrated pull-up resistor on
the /MR. An active-low push-pull reset output (/RESET)
and an active-high reset output (RESET) provide
flexibility when interfacing with various
microcontrollers, PMICs, or load switches. The
watchdog input can be left unconnected for
applications that do not require watchdog monitoring.
The MIC826 consumes a quiescent current of only
3.8 μA and is offered in a tiny, space-saving, 6-lead
1.6 mm x 1.6 mm UDFN package. It is rated for the
–40°C to +125°C temperature range.

Features
• Precision 1.8V to 5V Power Supply Monitor
• ±0.5% Threshold Accuracy at TA = +25°C
• ±1.5% Threshold Accuracy from TA = –40°C to +125°C
• 3.8 μA Supply Current (MIC826S/R/T/W/Y/Z)
• 4.8 μA Supply Current (MIC826L/M)
• Manual Reset Input
• 140 ms (min.) Reset Timeout Period
• 1.6s (typ.) Watchdog Timeout Period
• Float Watchdog Timer Input to Disable Watchdog Timer
• Active-High and Active-Low Push-Pull Outputs
• Ensured Reset Output Valid to VCC = 1V
• –40°C to +125°C Junction Temperature Range
• 6-Lead 1.6 mm x 1.6 mm x 0.5 mm UDFN Package
• 50% Smaller Version of MAX823/MAX824/MAX825/ADM823/ADM824/ADM825
• 8x Lower Watchdog Input Current than the Competition

Applications
• Microprocessor Systems
• Computers
• Intelligent Instruments