Applications
■ 3M™ Gripping Material GM613, GM630, and GM640 These plain backed products can be shear cut, die-cut, or converted by other applicable methods, and can be sewn to a wide variety of substrates using most commercially available equipment. Excessive thread tension may cause tearing or cutting of the product. Avoid direct contact with heated processing surfaces, in excess of 160°F (71°C), for prolonged periods of time. 3M™ Gripping Material GM614, GM631, and GM641 These pressure sensitive adhesive backed products can be shear cut, die-cut, or converted by other application methods. When used as a handle wrap, material should be wrapped so edges overlap opposite the stress direction. If wrapped handle is to be used in a pushing mode, overlap the wraps from top to bottom. If handle is to be used in pulling mode, overlap wraps from bottom to top. The leading and ending edges of the wrap should be secured with end caps or tape designed for that purpose, Minimum tension should be used to avoid stretching and distortion of the product. Avoid direct contact with heated processing surfaces, in excess of 160°F (71°C), for prolonged periods of time.