MPC5510 Family Features
• Single issue, 32-bit CPU core complex (e200z1)
   – Compliant with the Power Architecture™ embedded category
   – Includes an instruction set enhancement allowing variable length encoding (VLE) for code size footprint reduction. With the optional encoding of mixed 16-bit and 32-bit instructions, it is possible to achieve significant code size footprint reduction.
• Up to 1.5-Mbyte on-chip flash with flash control unit (FCU)
• Up to 80 Kbytes on-chip SRAM
• Memory protection unit (MPU) with up to sixteen region descriptors and 32-byte region granularity
• Interrupt controller (INTC) capable of handling selectable-priority interrupt sources
• Frequency modulated Phase-locked loop (FMPLL)
• Crossbar switch architecture for concurrent access to peripherals, flash, or RAM from multiple bus masters
• 16-channel enhanced direct memory access controller (eDMA)
• Boot assist module (BAM) supports internal flash programming via a serial link (CAN or SCI)
• Timer supports input/output channels providing a range of 16-bit input capture, output compare, and pulse width modulation functions (eMIOS200)
• Up to 40-channel 12-bit analog-to-digital converter (ADC)
• Up to four serial peripheral interface (DSPI) modules
• Media Local Bus (MLB) emulation logic (works with two DSPIs, the e200z0, the eDMA, and system RAM to create a 3-pin or 5-pin 256Fs MLB protocol)
• Up to eight serial communication interface (eSCI) modules
• Up to six enhanced full CAN (FlexCAN) modules with configurable buffers
• One inter IC communication interface (I2C) module
• Up to 144 configurable general purpose pins supporting input and output operations and 3.0V through 5.5V supply levels
• Real-time counter (RTC_API) with clock source from external 32-kHz crystal oscillator, internal 32-kHz or 16-MHz oscillator and supporting wake-up with selectable 1-second resolution and > 1-hour timeout, or 1-millisecond resolution with maximum timeout of one second
• Up to eight periodic interrupt timers (PIT) with 32-bit counter resolution
• Nexus development interface (NDI) per IEEE-ISTO 5001-2003 Class Two Plus standard
• Device/board test support per Joint Test Action Group (JTAG) of IEEE (IEEE 1149.1)
• On-chip voltage regulator (VREG) for regulation of 5V input to 1.5V and 3.3V internal supply levels
• Optional e200z0, second Power Architecture based I/O processor with VLE instruction set
• Optional FlexRAY controller
• Optional external bus interface (EBI) module