ST72325AR7-Auto datasheet(183/243 Pages) STMICROELECTRONICS

183 / 243 page

Obsolete

Product(s)

- Obsolete

Product(s)

ST72325xxx-Auto

Instruction set

Doc ID 13770 Rev 3

183/243

18.1.2

Immediate

Immediate instructions have 2 bytes. The first byte contains the opcode and the second byte

contains the operand value.

18.1.3

Direct

In Direct instructions, the operands are referenced by their memory address.

The direct addressing mode consists of two submodes:

Direct (short)

The address is a byte, thus requires only one byte after the opcode, but only allows 00 - FF

addressing space.

Direct (long)

The address is a word, thus allowing 64 Kbyte addressing space, but requires 2 bytes after

the opcode.

18.1.4

Indexed (no offset, short, long)

In this mode, the operand is referenced by its memory address, which is defined by the

unsigned addition of an index register (X or Y) with an offset.

The indexed addressing mode consists of three submodes:

Indexed (no offset)

There is no offset, (no extra byte after the opcode), and allows 00 - FF addressing space.

Indexed (short)

The offset is a byte, thus requires only one byte after the opcode and allows 00 - 1FE

addressing space.

Indexed (long)

The offset is a word, thus allowing 64 Kbyte addressing space and requires 2 bytes after the

opcode.

Table 100.

Immediate instructions

Instruction

Function

Load

Compare

BCP

Bit Compare

AND, OR, XOR

Logical Operations

ADC, ADD, SUB, SBC

Arithmetic Operations

ST72325AR7-Auto Fiches technique(PDF) 183 Page - STMicroelectronics

ST72325AR7-Auto Fiches technique(HTML) 183 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL